Condensate pump hook up

condensate pump hook up

How do you hook up a high voltage condensate pump?

Twist a wire nut over each pair of wires. Connect the condensate pumps high-voltage wires. If the condensate pump model has a high-voltage cord with a plug, then insert the plug into a wall receptacle.

How does a condensate pump work on an air conditioner?

When an air conditioner removes humidity from the air, condensate or water forms. The water flows out of the coils drain pan into the condensate pumps holding tank. Once the water reaches a set level in the holding tank, the condensate pump turns on and forces the water through a drain pipe.

How do I wire a condensate pump to a low voltage thermostat?

The condensate pumps low-voltage wire set contains two thin wires, usually 18-gauge wire. Remove the wire nut holding the thermostats red wire to one of the transformer low-voltage wires and separate the two wires. The transformer has two low-voltage wires: one connects to the ground lug, and the other sends power to the thermostat.

What to do if the condensate pump fails?

This way, if the condensate pump fails the safety switch (yellow wires), it will stop the furnace/AC and no more water from condensate will be generated. If heating or AC are a must, then connect the yellow wires to an alarm. Thanks!

How do you wire a condensate pump to an air handler?

Run the condensate pumps low-voltage wires into the air handlers electrical connection box. The condensate pumps low-voltage wire set contains two thin wires, usually 18-gauge wire.

How do I wire a condensate pump to a low voltage thermostat?

The condensate pumps low-voltage wire set contains two thin wires, usually 18-gauge wire. Remove the wire nut holding the thermostats red wire to one of the transformer low-voltage wires and separate the two wires. The transformer has two low-voltage wires: one connects to the ground lug, and the other sends power to the thermostat.

How do you fix a condensate pump that wont turn on?

Unplug the condensate pump or isolate the power source and fill the pump basin with water. See if your appliance runs or not. If it runs, make sure youve filled the basin with enough water so that it activates the float switch. Youll know the switch is working when it interrupts the system operation.

What voltage does a condensate pump use?

On many air conditioning systems, the air handler, which is where the condensate pump is generally located, uses high voltage (220/230/240 volts). Another thing to consider when selecting a condensate pump is whether or not your pump has a float switch built in. Be sure to get the right pump for your specific application.

What to do if your condensate pump is not pumping water out?

If your condensate pump is not pumping water out or not working as it should, follow these step by step directions. Step 1. Turn off your air conditioner. To be extra safe, shut off power at the breaker panel too. No sense in risking electric shock. Step 2. Locate the pump.

How do I know if my condensate pump is broken?

Step 1. Turn the Power off to Your AC and Condensate Pump If you suspect your condensate pump might be broken, turn the power off to your AC and the condensate pump. Make sure you turn off the power to the high voltage and low voltage wires from the pump. Step 2. Check the Float

How does a condensate pump work on an outside drain?

Some HVAC systems would require a condensate pump to drain water out through a tube and into an outdoor or basement drain. A condensate pump has a float switch which activates the pump to drain water out of the pan when it reaches the set limit. When water is drained, the float switch turns the pump off.

Why does my condensate pump keep shutting off?

Similarly, sometimes the float can become stuck thanks to a buildup of algae or debris. When this happens, it can cause the condensate pump to shut off. If the float is stuck, gently tap on it until it moves freely. Take notice of the condition of the float. If it’s cracked or damaged, it will need to be replaced.

Related posts: